TensCare unicare Bedienungsanleitung Seite 39

No sensation Intensity level is not high
and no LEADS enough and/or reduced
alarm sensitivity in the area being
showing treated.
No sensation Position is not optimal –
on one side of needs adjusting.
the probe (or
electrode)
Sudden If you disconnect and re-
change in connect a few minutes
sensation later, the signal will feel
quite a lot stronger.
The patient is an intended operator. There are no user-serviceable parts inside
the unit, and no calibration is required.
If the above review has failed to resolve your problem, or to report unexpected
operation or events, call TensCare or your local dealer (address on back cover)
for advice.
professional to discuss other suitable
options.
iii) Optional probes and probe sizes are
available. See accessories.
i) Please make sure you are increasing the
intensity high enough. Most people will
start to feel the stimulation in their hand
at around 25 mA and with the probe
inserted you will need to increase the
intensity higher to around 40 mA – 60 mA.
Max power is 99 mA. Everyone is different
so just keep increasing the intensity until
you can feel it. The intensity increases in
very small steps of 1 mA.
ii) You may have reduced sensitivity due to
previously damaged or desensitised
pudendal nerves (this can happen in
childbirth or some surgical procedures).
Please consult
professional.
The current flows from one side of the
probe to the other, so it is not possible to
have one side "not working". However, the
strength of the sensation depends on how
close to the nerve the current flows, and
also in which direction it flows relative to the
nerve. You can try slightly adjusting the
position on the probe or exchanging the
connection of the wires in the probe.
Always return strength
disconnecting the lead or the probe.
38
your healthcare
to zero after