Connect IT CEP-1000 Serie Benutzerhandbuch Seite 5

BLUETOOTH EARPHONES
CEP-1000 series
5 Charging the Charging Case Battery
The battery of the charging case is charged by means of the supplied MicroUSB cable and a USB power adapter with an output of 5
V / max. 1 A (the power adapter is not included, but you can use, for example, a mobile phone adapter or the separately sold original
CONNECT IT adapter of the CONNECT IT adapter of the CWC-2015 series).
The charging case battery charging status can also be monitored with LED indicator
The charging status is displayed with four LED diods (4 diods means that the case is fully charged).
Smart detection function for switch-off:
The charging case is equipped with a smart detection function that determines when both earphones are fully charged. The internal
circuit turns off after approx. 30 seconds to reduce the discharge of the charging case's internal battery.
Note:
The case can be charged with or without the earphones inside.
6 Operation and Charging of the Earphones
To charge the earphones, put them into the slots of the charging case; the slots are equipped with magnets to fix the earphones easily.
Automatic detection of the charging function:
As soon as an earphone is inserted in the charging case, the case detects it and starts charging it automatically.
Caution:
The left earphone must be inserted in the left part and the right earphone in the right part of the charging case. Otherwise
the fixing magnets are not correctly polarized and the earphones cannot be inserted properly.
Pairing with a phone
1. Open the charging case and take out both earphones. The earphones are switched on automatically and the pairing starts, which is
indicated by the flashing of the LED indicator
2. Under the Bluetooth section in your mobile, find the pairing name „CONNECT IT CEP-1000-BK / CEP-1000-WH" and have the
devices paired.
A 9
alternately in blue and red.
CONNECT IT®️ is a registered trade mark
A 4
.
R202103-IM
USER MANUAL
EN
4