Kidwell LUXI Benutzerhandbuch Seite 16

SEAT COVER AND HEADREST
4
Installation: pull the seat cover over the frame and fasten the Velcro fl aps on the back.
To attach the headrest, the Velcro fl ap should go through the loop located on the top
of the seat cover.
Removal: to take off the seat cover simply detach the Velcro, and pull out the fabric
of the metal frame.
CANOPY AND TOYS
5
Installation: To attach the toys to the canopy simply pull the Velcro fl ap through
the two possible loops. Once the toys are connected to the canopy fasten the clasps on
the swing frame on both sides. The canopy part with the elastic fi nish should go behind
the seat, so that it overlaps the back of the headrest area of the swing. The mosquito net
can be quickly attached to the canopy with a zipper.
Removal: Pull out both clasps of the canopy to remove it.
NOTE: the seat cover has small fabric fl aps which reveal the metal frame. Thanks to
this, the canopy is more securely attached to the frame. After the canopy net has been
removed, the fl aps should be closed to hide access to the frame.
SAFETY BELT INSTRUCTION
6
Place the baby into the bouncer and remember to adjust the seat belt on both sides
equally. The buckle of the safety belts is located in the crotch support restraint. It can be
easily accessed by pulling on the Velcro attachment.
NOTE: Make sure that the safety belt is fi tted for the child.
WARNING: To ensure the safety of the child make sure that the safety belt is properly
connected to the buckle before using the bouncer.
MOTION LOCK
7
Push the motion lock down to lock the bouncer in the starting position. Pull the motion
lock up to unlock the rocking motion.
WARNING: do not try to engage the lock while the bouncer is in motion.
POWER SUPPLY
8
Plugin the adapter into the swing as shown in the picture. The socket is located on the
inside of the base.
16