Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Section 2: General Information
February 2021
Section 2: General Information
2.1
2.2
2
General Application
The EL-O-Matic F Rack and Pinion actuators are intended for the
automation and operation of quarter-turn valves like Butterfly, Ball
and Plug valves.
Rack and Pinion actuators can also be used to operate venting louvers
or any other quarter-turn applications.
This product was intended for a specific range of service conditions:
pressure, ambient temperature, operating media, and possibly other
specifications. Do not expose the product to service conditions or
variables other than those for which the product was intended.
If you are not sure what these conditions or variables are, contact
your Emerson sales office for assistance. Provide the product type,
size, serial number and all other pertinent information that you
have available.
Inspection and Maintenance Schedules
The EL-O-Matic F Rack and Pinion actuators must be inspected
periodically and maintained as needed. Refer to the maintenance
section of manual DOC.IOM.EF.EN for more detailed information.
The schedule for inspection can only be determined based on the
severity of your service conditions. Your installation might also be
subject to inspection schedules set by applicable governmental
codes and regulations, industry standards, company standards, or
plant standards.
In order to avoid increasing dust explosion risk, periodically clean dust
deposits from all equipment.
When equipment is installed in a hazardous area (potentially explosive
atmosphere), prevent sparks by proper tool selection and avoiding
other types of impact energy.
Proper care must be taken to avoid generation of static electricity on
the non-conductive external surfaces of the equipment (e.g. rubbing
of surfaces, etc.). The actuator's surface temperature is dependent
upon process operating conditions.
Safety Guide
DOC.SG.EF.EN Rev. 4
General Information
Werbung
Kapitel
Inhaltsverzeichnis
