Herunterladen Inhalt Inhalt Diese Seite drucken

Fitting Instructions; Important Information - Ofa Bamberg dynamics Soft Gebrauchsanleitung

Sprunggelenkorthese
Vorschau ausblenden Andere Handbücher für dynamics Soft:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 6

Important information

Ankle Joint Orthosis Soft
Introduction
Dear user, we are delighted that you have
chosen an Ofa Bamberg product and we
want to thank you for putting your trust
in us. Please take a moment to read this
product information through carefully to
ensure your Dynamics product works as
effectively as possible.
Ofa Bamberg wishes you a speedy
recovery!

Fitting instructions

The pictures that go with the fitting instructions
can be found on the inside cover (2) at the start
of the brochure.
1
To put the orthosis on, open the two wide Velcro straps
and place your foot on the heel part. Place the shells
against the ankle and leg and check the settings on the
heel part. If this has been adjusted correctly, the heel
part and shells will be flush but not too tight.
2
If necessary, correct the width of the heel part using
the Velcro fasteners on the shells.
3
Hold the orthosis against your leg with one hand. First
wrap the lower Velcro strap tightly around the shells
and fasten it, then fasten the upper Velcro strap in the
same way. You can then readjust the straps if necessary.
Ensure that the product is secure but not too tight so as
to prevent pinching.
Intended Use
The Dynamics Ankle Joint Orthosis Soft
provides optimal ankle stabilisation. The
anatomically-shaped shells prevent lateral
ankle twisting. Soft inner padding made
of memory foam fits the ankle perfectly,
offering high levels of wearing comfort.
Important information
– The initial fitting and adjustment of the product
as well as instructions on its proper and safe use
should be provided by trained medical/orthopaedic
specialists.
– The product should only be used for the indications
in the adjacent column.
– Check the product to ensure it is working and
check it for wear and damage before each use. You
should also ensure it is fitted correctly. Do not use a
product that is damaged.
– Wear the product directly on the skin. It should
only be worn over intact skin. If it is to be worn in
combination with other products, please discuss this
with your doctor first.
– Unless otherwise prescribed, the product should
be removed during long periods of rest (e.g. when
sleeping).
– If you experience an unpleasant sensation, severe pain
or other symptoms while wearing the product, remove
it and contact your doctor or specialist supplier.
– We use a comprehensive quality assurance system
to check our products. If you have any complaints,
however, please contact your specialist supplier.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis