Wellue B02 Handbuch Seite 9

Measure Procedure
Refer to picture-07
The monitor is designed to take measurements and store the measurement
values in memory for two people using User ID A and User ID B.
1. Sit comfortably in a chair with your feet flat on the floor.
2. Select your User ID (A or B).
Stretch your arm forward on the desk and keep relaxing, make sure the palm
of hand is upturned. Make sure arm is in correct position, to avoid body
movement. Sit still and do not talk or move during the measurement.
After the cuff has been appropriately positioned on the arm and connected
to the blood pressure monitor, the measurement can begin:
a) Press the Start/Stop button. The pump begins to inflate the cuff. In the
display, the increasing cuff pressure is continually displayed.
b) After automatically reaching an individual pressure, the pump stops and
the pressure slowly falls. The cuff pressure is displayed during the
measurement.
c) When the device has detected your pulse, the heart symbol in the display
begins to blink.
d) When the measurement has been concluded, the measured systolic and
diastolic blood pressure values, as well as the pulse will be displayed.
e) The appearance of this symbol signifies that an irregular heartbeat was
detected. This indicator is only a caution. It is important that you be relaxed,
remain still and do not talk during measurements.
f) The measurement results are displayed until you switch the device off. If no
button is pressed for 60 seconds, the device switches off automatically.
g) Cuff self-checking symbol ( )
The cuff correct symbol( ) will be displayed if the cuff position is correct,
otherwise the wrong symbol( ) will be displayed. Please check again the
cuff if the wrong symbol( ) is displayed.
h) Movement error symbol ( )
The Movement Error Symbol ( ) is displayed if you move your body during the
measurement. Please remove the cuff, and wait 2-3 minutes. Reapply the cuff
and take another measurement.
NOTE:
Patient Position:
1) Comfortably seated
2) Legs uncrossed
3) Feet flat on the floor
4) Back and arm supported
5) Middle of the CUFF at the level of the right atrium of the heart
Recommended Use Methods
1. Recommendation that the PATIENT relax as much as possible and not talk
during the measurement PROCEDURE
2. Recommendation that 5 min should elapse before the first reading is taken
3. Any reading can be affected by the measurement site, the position of the
PATIENT, exercise, or the PATIENT'S physiologic condition.
4. Performance of the AUOTMATED SPHYIGMOMANOMETER can be
affected by extremes of temperature, humidity and altitude.
5. To stop the inflation or measurement, push the START/STOP button. The
monitor will stop inflating, start deflating, and will turn off.
6. After the monitor has defected your blood pressure and pulse rate, the cuff
automatically deflates. Your blood pressure and pulse rate are displayed.
7. The monitor will automatically turn off after one minute.
one