Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
Caution!
Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent
person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Possible caus
Temperature regulation knob is set at coldest
Mains plug is not plugged in or is loose
Appliance does
not work
Fuse has blown or is defective
Socket is defective
Appliance
Temperature is set too cold or the appliance runs
freezes or cools
at coldest.
too much
Temperature is not properly adjusted.
Door was open for an extended period.
The food is not
frozen enough.
A large quantity of warm food was placed in the
appliance within the last 24 hours.
The appliance is near a heat source.
Heavy build up
of frost on the
Door seal is not air tight.
door seal
Appliance is not level.
The appliance is touching the wall or other objects. Move the appliance slightly.
Unusual noises
A component, e.g. a pipe, on the rear of the
appliance is touching another part of the appliance
or the wall.
Water on the
Water drain hole is blocked.
floor
Side panels are
It's normal. Heat exchange parts are in the sides.
hot.
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer to the rating plate.
fi200603
KG 185 A++
black steel
Solution
Set the knob at other switch on the appliance.
Insert mains
Check fuse, replace if necessary
Mains malfunctions are to be corrected by an electrician
Turn the temperature regulator to a warmer setting
temporarily.
Please look in the initial Temperature Setting section.
Open the door only as long as necessary.
Turn the temperature regulation to a colder setting
temporarily
Please look in the installation location section.
Carefully warm the leaking sections of the door seal with
a hair dryer (on a cool setting). At the same time shape
the warmed door seal by hand such that it sits correctly.
Re-adjust the feet.
If necessary, carefully bend the component out of the
way.
See the Cleaning and Care section.
Take gloves to touch sides if needed.
13
Werbung
