ISOtunes LINK AWARE Bedienungsanleitung Seite 18

This earmuff is provided with electrical audio input. The wearer should
check correct operation before use. If distortion or failure is detected, the
wearer should refer to the manufacturer's advice.
For additional information about ISOtunes® LINK Aware please visit www.
ISOtunes.com/LINKAwareManual. For additional information or questions
about ISOtunes® products or spares and accessories, please contact our
support team.
Replacement Parts: Hygiene Kit (ear-cushions and foam inserts) Model
Number: IT-83
Replace ear-cushions:
1. Put your finger between the ear cushions and foam.
2. Pull the Foam Ear cushion away from the earcup.
3. Remove the foam inserts in the earcup.
4. Install the new foam inserts
5. Snap the new ear-cushion in place on the earcup
The following information shall be available from the manufacturer on re-
quest:
a) results of tests performed in accordance with this standard;
b) the name and country of the test laboratory which performed the tests
specified and the date of the tests.
FCC
Caution: The user is cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void the users'
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC's RF radiation exposure limits set forth
for an uncontrolled environment. End users must follow the specific oper-
ating instructions for satisfying RF exposure compliance. This transmitter
must not be co-located or operating in conjunction with any other antenna
or transmitter.
UK & Europe
uk-eurosupport@isotunesaudio.com
North America
support@isotunesaudio.com
1-844-396-3737
Monday-Friday 9-5 ET
EN | 18