Setting Individual Addresses And Pulse Duration Of Outputs - Lenz Digital Plus LS150 Handbuch

Setting individual addresses and pulse durations of outputs
You can use this procedure to set individual outputs to adresses which do not
necessarily have to be sequential. Furthermore, you can also set the pulse
duration of the outputs.
Connect the LS150 to both the voltage supply and track output as described in
the Section "Anschluss
Digital plus by Lenz
Complete the following steps to set the address and pulse duration of an output.
1. Press the key on the LS150 and keep it down until the LED shines
continuously (this will take approx. 3 sec.). Release the key. The LED
remains switched on.
2. Press the key again for a short moment. The LED starts to flash:
1 x flash, break: output 1 is selected,
2 x flashes, break: output 2 is selected etc.
If you only want to set the pulse duration of an output and not its address,
press the key again and proceed with step 4.
3. Select the point address of the digital system to which you want to set the
selected output. Proceed as if you wanted to switch the chosen point and
press the corresponding key of the digital system
4. The LED starts to flash.
5. You can now set the pulse duration of the output. If you do not want to do
this, press the key again for a short moment and proceed with step 6.
Select a point address between 1 and 100 in the digital system, depending
on the desired pulse duration. Value 1 stands for 0.1 sec, value 100 for 10
sec. Proceed as if you wanted to switch the point. The LS150 will now take
on the point address selected as the pulse duration.
6. The LED will start to flash again as described in step 2. You can now set the
address and pulse duration of the second output. To set this output, go
back to step 3.
Repeat this procedure for all outputs of the LS150.
To complete the setting process, press the key until the LED turns off.
If you want to skip a certain setting, simply press the key again and the LS150 will
proceed to the next step. This also makes it possible to set a single output
separately.
If you want to stop the setting procedure at any given time, press the key until the
LED turns off.
2
For more information about switching the points of the respective devices of your digital
system, refer to the corresponding operating manuals.
des LS150"
®
system.
(Page 7). Then
2
.
27
switch on your
E