Abbott ALERE AFINION AS100 Bedienungsanleitung Seite 25

Using the control ID function
In quality control testing, a suitable control ID must always be entered. The lot number of the control material is recommended as
a suitable control ID. The control ID function cannot be disabled.
Entering control ID
It is recommended to enter the control ID during processing of the Test Cartridge in the Analyzer. Entering the control ID will
not interrupt the processing. It is also possible to enter the control ID before processing. Both letters and numbers can be entered
(maximum 16 characters). The control ID will be stored in the memory and displayed along with the other specific data for this run.
To enter the control ID during processing, do the following:
1
Touch
2
Enter control ID by numbers and/or touch
Touch
3
The entered control ID will appear on the screen.
The control ID touch button will remain in the view and make corrections possible.
to enter the control ID option.
to confirm and return to the previous view.
Testing Procedures
to enter letters.
EN | 23