DJI ZENMUSE L1 Kurzanleitung Seite 12

Controllable Range
Operation Modes
Data Storage
Raw Data Storage
Supported microSD Cards
Recommended microSD Cards**
Post-Processing Software
Supported Software
Data Format
* The accuracy was measured under the following conditions in a DJI laboratory environment: after a
5-minute warm up, using Mapping Mission with Calibration Flight enabled in DJI Pilot, and with the RTK
in FIX status. The relative altitude was set to 50 m, flight speed to 10 m/s, gimbal pitch to -90°, and each
straight segment of the flight route was less than 1000 m. DJI Terra was used for post-processing.
** The recommended microSD cards may be updated in future. Visit the DJI official website for the latest
information.
Download the latest version from
http://www.dji.com/zenmuse-l1
This content is subject to change.
DJI is a trademark of DJI.
Copyright © 2021 DJI All Rights Reserved.
10
Tilt: -120° to +30°, Pan: ±320°
Follow/Free/Re-center
Photo/IMU/Point cloud/GNSS/Calibration files
microSD: Sequential writing speed 50 MB/s or above and UHS-I
Speed Grade 3 rating or above; Max capacity: 256 GB
SanDisk Extreme 128GB UHS-I Speed Grade 3
SanDisk Extreme 64GB UHS-I Speed Grade 3
SanDisk Extreme 32GB UHS-I Speed Grade 3
SanDisk Extreme 16GB UHS-I Speed Grade 3
Lexar 1066x 128GB U3
Samsung EVO Plus 128GB
DJI Terra
DJI Terra supports exporting standard format point cloud
models:
Point cloud format: PNTS/LAS/PLY/PCD/S3MB