Care And Maintenance; Cleaning The Scanner; Cleaning The Outer Casing; Cleaning The Image Sensor - Braun Novoscan A6 Bedienungsanleitung

Care and maintenance

Cleaning the scanner

In order to maintain the best image quality and prevent dust
accumulation, please clean the outer casing and image sensor inside
the scanner regularly (about every 50-100 scans, or whenever
unwanted vertical/horizontal lines appear on the scanned image).
When cleaning, use only the recommended and supplied tools.
WARNING : Do not use any tools other than the supplied
ones to clean the image sensor inside the scanner. Otherwise
the image sensor will be permanently damaged.

Cleaning the outer casing

Please follow the instructions below to clean the outer casing of the
scanner when necessary.
1. Use a suitable dust blower to blow off the dust on the scanner.
2. Use a slightly dampened cloth to wipe off any smear on the
surface of the scanner.
3. Wipe the scanner with a dry and clean lint-free cloth.
WARNING
: Do not use any solvents or corrosive liquid (for
example, alcohol, kerosene..., etc.) to clean any part of the
scanner. Otherwise the plastic material will be permanently
damaged.

Cleaning the image sensor

1. Follow the instructions above to clean the outer casing of the
scanner first.
Care and maintenance
2. With the scanner power off and
disconnected from the power
supply, insert the sensor cleaning
swab into one end of the output
slot.
NOTE
: Make sure that
there is no visible dust on
the swab before inserting it
into the output slot.
23