knapp WALCO V60 Montageanleitung Seite 15

WALCO 60 VK
Art. - No. K700/Set
1. Machined edge
Minimum milled dimension
30
60
Milling depth at two-sided cut-out:
12 mm
2. Marking connector position with scribing jig
3. Assemble connector
Countersunk
head screw
8x80 mm
Collar bolt
TORX 30
Page 2/2
WALCO® 60 VK / V60
ETA-10/0189
7,5
Art. - No. K578
1connection contains
Set K700 and Set K100
Adjustability ± 10 mm *
* Slots can also be used
for adjustability!
4 Hex-head-wood
screws 6x50 mm
Assembly Instructions
WALCO V 60
Art. - No. K100/Set
1. Machined edge
Minimum milled dimension
depth
30
60
Milling depth at two-sided cut-out:
15 mm without joint => tight fitting
13 mm easy to connect (2 mm gap)
Milling depth at one-sided cut-out:
27 mm without joint => tight fitting
25 mm easy to connect (2 mm gap)
2. Marking connector position with scribing jig
3. Assemble connector
Wall connector
7,5
Art. - No. K578
TORX 30
4 Hex-head-wood
screws 6x50 mm
depth