knapp WALCO V60 Montageanleitung Seite 10

Collar Screw 12x60 mm
Art. - No. K102
1. Drilling
40
2. Screwing collar screw
O 8
Note: If the connector is installed in the sheeting
level, it can be adapted to 15mm sheeting by
using an additional DIN 125 M12 washer.
page 1/4
ETA-10/0189
40
TORX 30
Assembly Instructions
WALCO® V 60
WALCO V 60
1. Machined edge
Minimum milling dimensions (alternatively, the connector can also
be accommodated in the sheeting level 13 mm or 15 mm)
A
7,5
A
60
Holding screw
Collar screw
Retaining holding screw
Retaining spring holding screw
2. Marking Connector position with scribing jig
3. Assemble connector
Wall connector
A-A
depth
Depth T
13 mm without joint=> tight fitting
11 mm easy to connect (2 mm gap)
11 - 22 mm
11- 17 mm
Ø 4 depth 50mm
alternativ Ø 5 depth 10mm
Art. - No. K578
TORX 30
3 Hex-head-wood
screws 6x50 mm