knapp WALCO V60 Montageanleitung Seite 12

Collar bold holding screw
Art. - No. K108
1. Drilling
40
2. Screwing countersink screw into Collar bolt
SK 8x80
Hinweis: The fully threaded screw can also be
pre-drilled with a Ø5 mm drill !
If the connector is installed in the sheeting level,
it can be adapted to 15mm sheeting by using an
additional DIN 125 M12 washer.
Page 3/4
WALCO® V 60 VK D12
PositionierbohrungTi
efe/depth
50 mm
40
VK D12
TORX 40
Assembly Instructions
WALCO V 60
1. Machined edge
Minimum milling dimensions (alternatively, the connector can also
be accommodated in the sheeting level 13 mm or 15 mm)
A
7,5
A
60
Depth: 13 mm without joint => tight fitting
11 mm easy to connect (2 mm gap)
2. Marking Connector position with scribing jig
3. Assemble connector
Wall connector
A-A
depth
Ø 4 depth 50mm
alternativ Ø 5 depth 10mm
Art. No. K578
TORX 30
3 Hex-head-wood
screws 6x50 mm