Herunterladen Diese Seite drucken

Werbung

06.20 · Technische Änderungen vorbehalten · Technical amendments reserved · Modifications techniques réservées
!
Netzteil
Power supply unit
Boîtier d'alimentation
Gebrauchsanweisung
Anwendung
Netzteil mit DALI-Schnittstelle für
LED-Kompakttiefstrahler 32-86,4 W zum
Einbau in Zwischendecken.
Das Netzteil kann auch zusammen mit einer
Leuchte in das Einbaugehäuse eingesetzt
werden.
Produktbeschreibung
Gehäuse besteht aus Aluminiumguss
2 Befestigungslanglöcher
Breite 6,5 mm · Abstand 225 mm
2 Leitungsverschraubungen mit Zugentlastung
zur Durchverdrahtung der Netzanschlussleitung
von ø 5-13 mm
1 Leitungsverschraubung werkseitig mit
Blindstopfen verschlossen
0,5 m Verbindungsleitung mit Stecker zwischen
Leuchte und Netzteil
Primär: 200-240 V x 0/50-60 Hz
DC 176-280 V
DALI-steuerbar
Sekundär: 1.600 mA DC · 32-86,4 W
Schutzklasse I
Schutzart IP 65
Staubdicht und Schutz gegen Strahlwasser
c  – Konformitätszeichen
Gewicht: 1,1 kg
Sicherheit
Für die Installation und für den Betrieb
dieses Netzteils sind die nationalen
Sicherheitsvorschriften zu beachten.
Die Montage und Inbetriebnahme darf nur
durch eine Elektrofachkraft erfolgen.
Der Hersteller übernimmt keine Haftung für
Schäden, die durch unsachgemäßen Einsatz
oder Montage entstehen.
Werden nachträglich Änderungen an diesem
Netzteil vorgenommen, so gilt derjenige als
Hersteller, der diese Änderungen vornimmt.
Ø 6,5
145
145
Instructions for use
Application
Power supply unit with DALI-interface for
LED compact downlights 32-86.4 W for
installation in suspended ceilings.
The power supply unit can also be inserted
together with a luminaire in the installation
housing.
Product description
Housing made of aluminium alloy
2 elongated fixing holes
Width 6.5 mm · 225 mm spacing
2 screw cable glands with strain relief
for through-wiring power connecting cable
ø 5-13 mm
1 screw cable gland closed at the factory with
a dummy plug
0.5 m connection cable with plug between the
luminaire and the power supply unit
Primary: 200-240 V x 0/50-60 Hz
DC 176-280 V
DALI controllable
Secondary: 1.600 mA DC · 32-86.4 W
Safety class I
Protection class IP 65
Dust-tight and protection against water jets
c  – Conformity mark
Weight: 1.1 kg
Safety indices
The installation and operation of this
power supply unit are subject to national safety
regulations.
Installation and commissioning may only be
carried out by a qualified electrician.
The manufacturer is then discharged from
liability when damage is caused by improper
use or installation.
If the power supply is subsequently modified,
the persons responsible for the modification
shall be considered as manufacturer.
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info @ bega.com · www.bega.com
85
85
Fiche d'utilisation
Utilisation
Boîtier d'alimentation avec interface DALI
pour les spots compacts à LED 32-86,4 W à
encastrer dans les faux-plafonds.
Le boîtier d'alimentation peut également être
utilisé conjointement avec un luminaire dans le
boîtier d'encastrement.
Description du produit
Boîtier en matière fabriquée en fonderie d'alu
2 trous oblongs de fixation
largeur 6,5 mm · entraxe 225 mm
2 presse-étoupes avec décharge de traction
pour branchement en dérivation du câble de
raccordement réseau
de ø 5-13 mm
1 presse-étoupe fermée avec bouchon de
l'usine
Câble de raccordement 0,5 m avec fiche entre
le luminaire et le boîtier d'alimentation
Primaire: 200-240 V x 0/50-60 Hz
DC 176-280 V
Pilotage DALI
Secondaire: 1.600 mA DC · 32-86,4 W
Classe de protection I
Degré de protection IP 65
Etanche à la poussière et protégé contre les
jets d'eau
c  – Sigle de conformité
Poids: 1,1 kg
Sécurité
Pour l'installation et l'utilisation de ce boîtier
d'alimentation, respecter les normes de
sécurité nationales.
L'installation et la mise en service ne doivent
être effectuées que par un électricien agréé.
Le fabricant décline toute responsabilité
résultant d'une mise en œuvre ou d'une
installation inappropriée du produit.
Toutes les modifications apportées à ce boîtier
d'alimentation se feront sous la responsabilité
exclusive de celui qui les effectue.
13 574
IP 65
N  L
DA
DA
1 / 2

Werbung

loading

Inhaltszusammenfassung für BEGA 13 574

  • Seite 1 Hersteller, der diese Änderungen vornimmt. shall be considered as manufacturer. exclusive de celui qui les effectue. BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info @ bega.com · www.bega.com 1 / 2...
  • Seite 2 DEV-0300/1600 Bloc d’alimentation LED DEV-0300/1600 Dichtung Gehäuse 83 001 935 Gasket housing 83 001 935 Joint du boîtier 83 001 935 2 / 2 BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info @ bega.com · www.bega.com...