SUOMY mx speed pro Bedienungsanleitung Seite 27

Assembly — Figure 10
Turn upside down the cheek pads from the original position.
Insert the fixing hook (L) in the red hooking holes (M)
Put the back part of the cheek pad on the fixed part of the inner
lining. Verify that the fastening strap is correctly inserted in the
appropriate seat. Push the cheek pad to the back part of the helmet
and hook the press studs.
Repeat the operations on the opposite side.
Verify that the part was assembled correctly by checking that:
- the cheek pad is firmly locked in position
- the strap is completely free inside the hole and is not blocked
under the cheek pad during assembly.
FIGURE 10
-
Only the correct assembly of the cheek pad and the correct
positioning of the strap will assure the proper efficacy of the
retention system. During use, the locking lever must always be
fixed in lock position; if it cannot be locked correctly do not use the
helmet.
SECURITY SYSTEM — Figure 11
To remove the helmet in case of an accident
MX SPEED PRO is equipped with a system that easily remove the
cheek pads with the helmet worn in case of a crash
In case of emergency pull out the red tape (N) on the final part of
the cheek pads
L
M
FIGURE 11
N
27