KARE design 78848 Montageanleitung Seite 8

(pg 7 of 13)
Step 1. Remove and place to the side, the parts
packed above the Stainless Steel Top (#8). Please
note, the Solid Hardwood Board is packed within an
inner cardboard box.
Step 2. [ Use the Wrench (#25) for this step ] Open
the cardboard box containing the Stainless Steel Top
(#8). Locate the Back Frame (#4) and using Screw B
(#18) and Washers (#17), attach the "Top" of the Back
Frame (#4), as indicated by the attached sticker, to
the Stainless Steel Top (#8). The screw holes have
some tolerance, so make sure that the rear and sides
are as flush as possible with those of the Stainless
"teel Top – this ay save ti e y avoidi g havi g to
make slight adjustments later. The Stainless Steel Top
(#8) has no set front or back end.
Please Note: These assembly instructions for the
Rolling Workbench Cabinet have you assembling the
unit upside down. The screw holes used for attaching
the Back Frame and the Front Frame to the wood
board have some tolerance, as do the other parts. Be
aware that should a piece not fit correctly, the parts
can be moved around and adjusted slightly to achieve
a proper fit. When assembling a part, do not tighten
any one screw until all the screws for that part have
been partially screwed in.
Step 3. [Use Screw E (#16) for this step] Attach
Right Panel (#2) to Back Frame (#4), making sure the
"Top" of Right Panel (#2) is on the Stainless Steel Top
(#8).
78848
Dresser Efficiency Wood 1 Door 4 Drawers