Troubleshooting; Possible Cause - Redstone MT100 Original Bedienungsanleitung

Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with
the Directive (2012/19/EU) pertaining to waste electrical and electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can occur, for example, by handing it in at an authorised collecting
point for the recycling of waste electrical and electronic equipment. Improper handling of waste equipment may
have negative consequences for the environment and human health due to potentially hazardous substances that are
often contained in electrical and electronic equipment. By properly disposing of this product, you are also contributing to
the effective use of natural resources. You can obtain information on collection points for waste equipment from your
municipal administration, public waste disposal authority, an authorised body for the disposal of waste electrical and
electronic equipment or your waste disposal company.

18. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Cutting wheel is loose after
the motor is switched off
Motor does not start
Incorrect motor rotation
direction
Motor not supplying power,
fuse tripping
38 | GB
LEROY MERLIN • Rue Chanzy - Lezennes 59712 Lille Cedex 9 - FRANCE

Possible cause

Fixing nut not tight enough
a) Mains fuse blown
b) Extension cable faulty
c) Connection to the motor or switch
not OK
d) Motor or switch faulty
a) Capacitor defective
b) Incorrect connection
a) Cross section of the extension
cable insufficient
b) Overload due to blunt saw blade
Remedy
Tighten the fixing nut
a) Check the mains fuse
b) Replace the extension cable
c) Have this checked by an electrician
d) Have this checked by an electrician
a) Have this checked by an electrician
b) Have an electrician transpose the wall plug
poles
a) See "Electrical connection"
b) Replace the saw blade