Thomashilfen tGo Gebrauchsanweisung Seite 23

Adjusting the pad height
1. The height of the pelvis pad can be adjusted. To do this, the screw on the tube locator must be loosened. The pelvis
pad can now be slid up and down the tube to the desired height. Re-tighten the screw on the tube locator to secure
the pelvis pad (Fig. 17).
2. The height of the chest pad can be adjusted by moving the tube to which it is fastened. To do this, undo the screw
at the top of the chest pad tube (Fig. 25) and slide the tube to the desired height. Re-tighten the screw to secure the
chest pad.
3. The height of the torso pad can be adjusted. To do this, the screw on the tube locator must be loosened (Fig. 26).
The torso pads can now be slid up and down the tube to the desired height. Re-tighten the screw on the tube locator
to secure the pads.
Function of the torso pad
To make it easier for the child to enter the tGo the torso pad can be rapidly released via the locking lever and pulled
out from behind. The locking lever can also be used to adjust the depth of the torso pad. Always ensure that the locking
lever is returned to the locked position after making adjustments.
Adjusting the belt
The belt can be adjusted in length using the sliding buckle. (Fig. 30) The hook and loop fastener at the end of the belt
serves to open and close the belt. (Fig. 31).
Caution: The hook and loop fastener must always be fully closed when the child is in the tGo.
Changing the number of pads
The number of pads can be adjusted flexibly to the child. For instructions see „additional pad elements" in the section
„Fitting accessories".
Locking/releasing the swiveling function of the saddle
The child must first always be removed from the tGo when changing between the swinging function of the saddle and
its fixed position. Then remove the saddle of the tGo. Remove the Allen bolt and washer located at the lower end of
the saddle's threaded rod. Now pull the threaded rod out from below. The threaded rod has different shaped notches
on each end. When the threaded rod is slotted onto its locator with the rectangular notch at the top, the position of the
saddle is fixed and the swinging function is deactivated.
When the threaded rod is slotted onto its locator with its other at the top, the swinging function is activated. After mak-
ing this adjustment, refit the saddle to the tGo (for instructions on how to fit the saddle see section "Setup and assem-
bly").
Parking brake
To lock the parking brake, flip down the red levers (Fig. 27) located on the underside of the frame in front of the wheels.
This locks the brakes (Fig. 28). To release the parking brake, flip the red levers up.
Friction brake
The friction brake is applied using the red adjuster on top of the frame in front of the rear wheels. There is a mark on the
red adjuster. When this is pointing in the direction of travel the friction brake is released.
The braking action can be set progressively in five stages using the Allen wrench. To do this, turn the red adjuster anti-
clockwise (Fig. 29). When the adjuster is turned through the fifth position the mark will again be pointing in the direc-
tion of travel and the friction brake will be deactivated.
2021-04
Instructions for Use – tGo
23