MEDC DB1 Technisches Handbuch Seite 5

5.0 CERTIFICATION/APPROVALS
IECEx units
Certified to IEC60079-0 and IEC60079-1
DB1
Ex d unit (IEC certification No. IECEx BAS 10.0065X)
Ex d IIB T6 (Tamb. -20°C to +55°C) Gb
DB1H
Ex d unit (IEC certification No. IECEx BAS 10.0064X)
Ex d IIB T5 (Tamb. -20°C to +70°C) Gb
The IECEx certificate and product label carry the IECEx equipment protection level marking
Gb
Where Gb signifies suitability for use in a Zone 1 surface industries area in the presence of gas.
ATEX units
Certified to EN60079-0 and EN60079-1
DB1
Ex d unit (ATEX certification No. Baseefa02ATEX0207X)
Ex d IIB T6 (Tamb. -20°C to +55°C) Gb
DB1H
Ex d unit (ATEX certification No. Baseefa02ATEX0209X)
Ex d IIB T5 (Tamb. -20°C to +70°C) Gb
The ATEX certificate and product label carry the ATEX group and category marking:
II 2 G
Where:
Signifies compliance with ATEX
II Signifies suitability for use in surface industries
2 Signifies suitability for use in a zone 1 area
G Signifies suitability for use in the presence of gases
The ATEX certificate and product label also carry the following mark:
This signifies unit compliance to the relevant European directives, in this case 94/9/EC, along with the number
of the notified body issuing the EC type examination certificate.
6.0 SPECIAL CONDITIONS FOR SAFE USE (IECEx and ATEX)
1. The enclosure is a potential electrostatic charging hazard, and should only be cleaned with a damp cloth.
© Cooper MEDC 2010 02/11