Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ConStands Easy Plus
Use: Front
Scope of delivery / Parts list
Required tools:
Open-end spanner: SW13
●
Allen key: 5 mm
●
Pos
Scope of delivery
A
Side part (left / right)
B
Wheel holder
C
Wheel rocker
D
Support
1
Screw M8x35 (Hexagon socket)
2
Nut M8
3
Washer
4
Locking plate
5
Locking screw M8x16
Mounting
A
Step 1: Mount the side parts A to the wheel holder B,
use the screws 1 M8x35, the washers 3 and the nuts
2 M8.
B
Step 2: Mount the support D, using the screws 1
M8x35, the washers 3 and the nuts 2 M8.
C
Step 3: Insert the wheel rocker C and the locking
plates 4 into the carrier D.
D
Step 4: Secure the locking plates 4 with the locking
screws 5.
ATTENTION: Please check that the motorbike is standing firmly when using the stand for the first time.
The wheel must be locked in securely to the front and rear.
Mounting Instruction
General Information
Thank you for purchasing a ConStands wheel chock.
Please read the following installation instructions carefully. Motea GmbH accepts no
liability for damage to property and/or personal injury resulting from improper or faulty
installation or use.
Please check the correct function before each use.
Re-tighten the screws if necessary.
Subject to technical or design changes, printing errors and mistakes.
Qty
1 each
1
1
1
10
10
10
2
4
A
C
Locking plate (4)
B
A
C
B
D
Locking screw (5)
EN
A
D
4
1
3
2
5
Page 1/1
Werbung
