X Rocker Elite Pro Handbuch Seite 3

ENG
Switch™ Mode
Console Mode
First time to Pair & Connect(Y+Home)
(Power on your console, then follow these steps to pair and connect
your controller.)
Step 1. Select the Controllers option on the home screen.
Step 2. Select change Grip/Order.
Step 3. Press Y+Home button at the same time, the LED Indicator
will blink, wait a few seconds for the connection to complete.
Reconnect (Home)
Reconnect: Press Home Button
If your controller was once paired and connected to your console,
press the Home button to reconnect.
NOTE: Please ensure that the console is turned on to complete
reconnection of the wireless Pro controller.
You may need to reconnect your controller as per the initial setup
instructions to reconnect after a firmware update.
Analogue Stick Calibration:
A. Press Home button to enter the main menu of the console and
select System Settings.
B. In the Controllers and Sensors menu, select
Calibrate Control Sticks.
C. Follow the on screen instructions to complete calibration.
D. Then press 3D (L3/R3) step into below interface.
E. And then press X button step in to calibrate interface, and do
actions based on the remind.