Protecting The Environment - Stanley FL5W10 Anweisungshandbuch

3. To turn on the spotlight, rotate the on/off power knob to the furthest position
counterclockwise.
4. To turn off the spotlight, rotate the on/off power knob to the furthest position clockwise.
Note:
The battery/charge status LED indicator will light in
one of three colours (as described in the "Reading the Battery/Charge Status LED" section) to
indicate the battery status. It is visible through the translucent waterproof end cap.
using the dimmer selector
The dimmer selector knob that adjusts the light intensity is
located above the on/off power knob. Push and turn it to
the left, then hold for 2 seconds to select a
brighter setting. Push and turn it to the right, then hold for
2 seconds to select a dimmer setting.* A "beep" will sound
twice when the spotlight has been adjusted to its minimum
(dimmest) or maximum (brightest) settings.
* The battery/charge status LED indicator will flash red to indicate the light is adjusting to a brighter
setting or flash green to indicate the light is adjusting to a dimmer setting.
On a single charge, the spotlight will provide steady illumination for approximately 10
hours on its minimum (dimmest) setting; approximately 50 minutes on its maximum
(brightest) setting.
Important:
To avoid sustaining damage, this spotlight should not be used under water for
any longer than one hour.
trouBlesHootInG
the battery/charge status indicator led does not light when
charging
1. The battery is in overheat protection after extensive use. Allow the spotlight to cool
down for several minutes before recharging.
2. The spotlight will not charge when operating. Make sure the spotlight is turned off.
3. Check connection to the charging socket.
4. Check connection to AC or DC power source.
5. Confirm there is a functioning AC or DC current.
unit will not operate
1. The battery is in overheat protection after fully charging or recharging. Allow the
spotlight to cool down for several minutes before operating.
ENGLISH
FL5W10EU_Manual_040612.indd 8-9
DIM
BRIGHt
OFF
ON
8
2. The spotlight will not operate when charging. Be sure all adapters are disconnected
before spotlight use.
3. The battery may be completely discharged. Charge the unit following the directions.
4. If the spotlight does not operate after recharging as directed, contact manufacturer.
MaIntenance
If the unit gets dirty, gently clean the outer surfaces of the closed body casing with a soft
cloth moistened with a mild solution of water and detergent.
Make sure the unit is thoroughly dry before storage. If the unit has been submerged, wipe
it dry with a soft cloth.
There are no user-serviceable parts inside. Contact the manufacturer if any components
have become worn or broken.
WARNING: Before performing any maintenance or cleaning on the unit, disconnect it
from any power source.
12 volt dc charger plug fuse replacement
The fuse in the plug end of the DC charger protects the adapter's charging circuit. If the mains
AC charger operates, but the DC charger does not, then this fuse may be opened (blown).
To replace the fuse:
1. Unscrew the end cap of the DC plug (counterclockwise).
2. Remove spring center contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate a replacement 5 amp/250 volt fuse.
5. Replace the fuse, spring, contact and end cap.
6. Screw end cap clockwise until it is finger tight – DO NOT OVER-TIGHTEN.
7. Test for proper operation of the DC charger.

protectInG tHe enVIronMent

correct disposal of this product
This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was purchased.
They can take this product for environmentally safe recycling.
9 ENGLISHn
4/6/2012 12:05:14 PM