Operation - Makita DML811 Betriebsanleitung

• Be careful not to trap finger(s) between the appliance
and battery cartridge when loading battery cartridge as
well as between the appliance and the battery cover
when closing the battery cover.
To install the battery cartridge, release the cover lock,
and open the battery cover. (Fig. 1)
Insert the battery cartridge. Align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place with
a little click. If you can see the red indicator on the upper
side of the button, it is not locked completely. Then close
the battery cover. (Fig. 2)
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
CAUTION:
• Always install the battery cartridge fully in place. If not,
it may accidentally fall out of the appliance, causing
injury to you or someone around you.
• Do not install the battery cartridge forcibly. If the
cartridge does not slide in easily, it is not being
inserted correctly.
Indicating the remaining battery capacity
(Fig. 3)
(Only for battery cartridges with the indicator)
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Indicator lamps
Lighted Off
NOTE:
• Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the
actual capacity.
Use of non-genuine Makita batteries, or batteries that
have been altered, will void the Makita warranty for the
Makita appliance and charger.
Use with AC power:
When using the appliance with AC power, use the power
cord which is supplied with the appliance. Let the female
plug insert to the appliance and connect the male plug to
an outlet. (Fig. 4)
Remaining capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the battery.
The battery may
have malfunctioned.
CAUTION:
• Insert the female plug into the appliance first
completely, then connect the male plug to an outlet.
• Always close the socket cover firmly when the power
cord is not plugged.
NOTE: The AC power does not charge the battery
inserted to the appliance.
NOTE: Even operating in DC power, the appliance
automatically changes to AC power when the power cord
is plugged in.
Organizing the power cord:
Coil power cord on stand tightly, then clip end of the cord
by using fastener attached. (Fig. 5)
Turning on the light and brightness mode selection
(Fig. 6)
1. Switch : Press the switch once, the light turns on (At
the same brightness mode as the last setting). Press the
switch again, the light turns off.
2. Brightness mode selection: Brightness sequence is :
High mode / Mid mode / Low mode / High mode for each
press when the light is on.
Battery protection system (Fig. 7)
The appliance is equipped with a battery protection
system to extend battery life. When the battery becomes
low, the LED lights go out except one LED as illustrated.
Then approximately five to ten minutes later, the system
automatically cuts off power.

OPERATION

CAUTION:
• Always put the appliance on flat and stable place.
Otherwise a falling accident may occur.
Adjusting the angle of the light (Fig. 8)
Loosen the knobs on the both side. Adjust the angle of
the light (adjustment range is 240°). Then tighten the
knobs again.
CAUTION:
Take care not to trap finger(s) when adjusting the angle
of the light.
Using with tripod (optional accessories)
CAUTION:
• Read carefully the instruction manuals of the
accessories before using them with the light.
You can put the light on the tripod to facilitate the
operation. (Fig. 9)
CAUTION:
• Be careful not to drop the appliance when attaching
the appliance on the tripod.
• Place the tripod on a level and stable surface to
prevent from falling.
• Spread the legs of the tripod to the maximum.
• Do not use the tripod if the wind is strong.
• Make sure that the appliance is attached securely on
the tripod.
• Remove the appliance when carrying the tripod or
when folding the legs of the tripod.
• Be careful not to get your hand caught in the legs of
the triopd when closing the tripod.
7