Cleaning And Care - WMF Kult X Gebrauchsanweisung

Speed Use
1–2 Instant drinks, soft fruits and alcoholic cocktails
1–2 Milkshakes
3–4 Soups, milkshakes with harder fruits, sauces, baby foods, vegetables
4–5 Nuts, hard cheese, dry bread
Switch the device off as soon as the amount is processed. Never operate the appliance empty.
Allow the device to cool down following the maximum operating time so that the motor is not
overloaded.
Always turn the selector switch to the OFF position before removing the glass jug.
Crushing ice cubes
Fill with a maximum of 10 ice cubes and close the glass jug with the lid and closing cap. Turn the
selector switch for a few seconds to the pulse stage P and then back to the OFF position. As soon as
the ice cubes fall back to the bottom of the glass jug, you can switch to the pulse stage P again for a
few seconds. Repeat the process until the crushed ice has the desired consistency.

Cleaning and care

Caution: Before cleaning the drive unit, you must pull out the mains plug! The drive unit should never
be placed in water, only wiped down with a damp cloth. Never use abrasive cleaning agents.
Risk of injury: Be sure to avoid injury on the sharp blades when cleaning the glass jug.
Fill the jug with warm water immediately after use and allow the motor to run for a few seconds. Then
remove the glass jug and clean carefully with a washing-up brush.
The mixing container can be dismantled and the blade unit removed, especially for thorough cleaning.
To do so, place the jug on a table with the opening facing downwards and rotate the locking base in a
clockwise direction. For an easy detaching of the blade unit, you can use the lid of the glass jug. Place
it on the lower side of the blade unit and turn it clockwise until the blade unit is loose. (You can use
the same method to attach the blade unit again after cleaning.) You can now remove the blade unit
and sealing ring.
To assemble, the sealing ring is first attached to the blade unit. When doing so, make sure the sealing
ring is properly seated on the blade unit. Place the locking base on the mixing container and turn it
counter-clockwise as far as it will go.
Note: In order to ensure the tightness of the glass jug, the threaded ring must be screwed on tightly.
Observe the corresponding marking.
For quick and easy cleaning, all the loose parts of the mixing container can be washed in the
dishwasher.
14
Maximum time
40–60 secs
1–2 mins
1.5–2 mins
40–60 secs