Wireless Functions - Starrett W798 Handbuch

Wireless Functions

– The new Wireless button (Fig.5) on the W798 Caliper is used for
these three functions; wireless on/off, sending a reading, and to
change/reset a function in profile mode.
– You can turn the wireless "On" or "Off" by pressing and holding
the Wireless Radio Button for more than two seconds. The
display will show the current wireless state either "On" or "Off"
(Fig.3A-B). When you release the button, the new state, either
"on" or "off" will be shown on the display for two seconds, and
then the tool will revert back to the current reading. You can tell
that the wireless is on when you see the wireless symbol on the
display, Fig.5.
– When the radio is active, a short press on the radio button will
transmit a reading, however, if the radio is off, nothing will
happen. The wireless icon (Fig.5) on the display will be shown
only when it is on and will flash when the tool is communicating
with another device.
– If you press and hold the Wireless button, you will go into the
functions mode and be able to change between the three
functions. The tool will display either " On" or "Off" and then
the current function. If you continue to hold the Wireless button,
and then press the In/mm button, the tool will cycle through the
functions one at a time. When the desired function is displayed
release the Wireless button to select the function.
WIRELESS OVERVIEW
PKG08862-UMW798 7