UNILITE PS-HDL6R Bedienungsanleitung

ANSI FL 1 STANDARD
RECHARGEABLE BATTERY
HIGH
MED
LOW
FLASH
ANTI-DAZZLE SCREEN
BATTERY INSTALLATION
1. Open the headtorch battery
compartment by very gently lifting
the clasp on the top of the headtorch.
2. Insert either the Unilite Li-Polymer
battery or insert 3 x high quality AAA
alkaline batteries into the battery
cartridge, then insert the cartridge
into the headtorch. Make sure you
take note of the polarity marks to
insert the correct way.
3. Then close the headtorch
until the clasp on the top
clicks shut.
3.7v 1800mAh/6.66Wh
Caution:
When recharging, use the battery charger specifically for that purpose.
Do not use or leave the battery at high temperature.
Do not discard the battery in fire or heat it.
Do not short-circuit the battery or strike at battery with
any sharp edge objects.
Rechargeable Li-Polymer
Battery (3.7v 1800mAh)
WWW.UNILITE.CO.UK
350
27 M
Lumens
140
16 M
Lumens
30
6 M
Lumens
-- --
Polarity Marks Charge Connectors
3 x AAA Battery
Cartridge
FEATURES
• High-power 350 Lumen white
SMD LEDs, 6500k
• Super wide flood of light
• Powerful rechargeable lithium
battery
• With 3 x AAA battery cartridge
• Anti-dazzle retractable
light shield
BATTERY - 1 x 3.7v 1800 mAh li-polymer rechargeable battery (inc)
1 x Battery Cartridge for 3xAAA Batteries (inc) [batteries not inc]
WEIGHT - 86g - with rechargeable lithium battery
94g - with 3xAAA batteries & case
DIMENSIONS - Headtorch: H:50 x W:65 x D:45mm
OPERATION
Pull out the anti-dazzle shield to reveal switch.
Switch Sequence - HIGH > MED > LOW > FLASH > OFF
(If left in any mode for 3 seconds, next press will turn OFF)
3 x AAA ALKALINE BATTERIES
3½ H HIGH
7 H
MED
47 H
LOW
21 H
FLASH
BATTERY LEVEL INDICATOR
CHARGING THE RECHARGEABLE BATTERY
1. Only use a USB type-C 5v cable (1m Cable included)
2. Remove rechargeable battery from headtorch.
3. Plug the USB-C end of the cable into the charge port on the side of
the battery.
4. Plug the USB end of the cable into any USB charging port
(for USB plug adaptors, only use 5V max 1A output).
5. Red LED indicates charging, Green LED indicates fully charged.
6. Charge Time: 4 hrs
**Warranty void if not used with the specified chargers**
3.7v 1800mAh/6.66Wh
Caution:
When recharging, use the battery charger specifically for that purpose.
Do not use or leave the battery at high temperature.
Do not discard the battery in fire or heat it.
Do not short-circuit the battery or strike at battery with
any sharp edge objects.
• 45° Rotational head
• IPX6 water resistant
• Fully adjustable non-slip
silicone headband
• 3M VHB Helmet mount included
• USB Type-C charging -
4 hours
• 1m Charging Cable included
350
Lumens
140
Lumens
30
Lumens
--
Blue
Red
Flash
USB Type-C
Red
Green
PS-HDL6R
27 M 2 H
16 M 6½ H
6 M 59 H
-- 24 H
30%
30%-5%
5%
Charging
Fully Charged