UNILITE PS-HDL1 Bedienungsanleitung

MICRO LED HEADLIGHT
FEATURES
200 Lumen white CREE LED on Boost
3 main beam functions - Boost / High / Low
1 floodlight function - High
Easy push button micro switch
Ultra-smooth reflector
45° rotational head
Fully adjustable non-slip silicone headband
IPX6 water resistant
BATTERY - 2 x 1.5v AAA Alkaline Energizer Batteries (included)
DIMENSIONS - Headlight: 37 x 60 x 33mm
WEIGHT - 69g (with batteries)
Only use high-quality Alkaline batteries or Ni-MH rechargeable batteries.
DO NOT USE rechargeable LITHIUM batteries, these will damage your headlight as they exceed rated voltage.
Do not use batteries of different brands or mix old and new batteries. Please recycle used batteries responsibly.
Battery life is affected by different battery brands, different ambient temperatures and different lighting modes.
Do not use this product in extreme cold or hot environments (below -30°C or above 60°C).
This product is water resistant to IPX6 - DO NOT SUBMERGE.
If the product has been affected by damp, remove the battery and dry the battery and allow the headlight to dry completely before using.
Take care not to let the lens come into contact with hard/sharp objects. Damage to the lens will affect the light output.
If you are not using the product for long periods of time (3 weeks or more), remove batteries to prevent battery leakage and battery depletion.
If the batteries are installed and the headlight does not work, try checking for the following:
- Press the switch button several times.
- Check that the batteries are inserted the correct way around, according to the polarity markings.
- Check there is no debris on the contacts that might affect the battery connection.
- Check there is no water or dampness in the light. If so, allow it to fully dry out and try again.
Before the product is used be sure to read this manual carefully for proper instructions and maintenance guidance.
Children under 12 years of age should only use the product with adult supervision.
Do not disassemble or attempt to modify this product. This will void the warranty. Improper use or battery leakage is not covered under warranty.
INSTRUCTIONS FOR USE
Boost
Press and hold down
(If left in any mode for over 3 seconds, the next press will turn OFF)
BATTERY INSTALLATION
Unilite International Ltd, The LAB, Winyates Way, Moons Moat North Ind. Est., Redditch, Worcestershire, B98 9FG – England, UK
T 00[44] 1527 584 344 F 00[44] 1527 584 345
High
Press
1. Pull the head away from the bracket
E sales@unilite.co.uk
TECHNICAL PARAMETERS
BOOST
HIGH
LOW
FLOODLIGHT
Low
Press again
3. Insert 2 x AAA alkaline batteries according to polarity labels
W www.unilite.co.uk
200
90 M
Lumens
160
80 M
Lumens
25
15M
Lumens
40
10M
Lumens
Floodlight
Press again
2. Lift clip to open battery compartment
PS-HDL1
5 H
5.5 H
30 H
10 H
OFF
Press again