PeakTech 1006 Bedienungsanleitung Seite 30

Square Wave
Rise or fall time
Aberrations
Triangle Linearity error < 1 % up to 100 kHz
Sine Wave Distortion
Sync Output
(TTL Pulse)
Source Impedance
Frequency Range
Symmetry/Duty Cycle
DC Offset
Sweep
Width
Rate
VCO Characteristics
Input impedance
Frequendy Range
Frequency Counter & TCXO
Range
Resolution
Time base
Attenuation
Sensitivity
TXCO
General
Weight
Dimensions
Operating Temp.
Storage Temp.
Power
All rights, also for translation, reprinting and copy of this manual or parts are reserved.
Reproductions of all kinds (photocopy, microfilm or other) only by written permission of the publisher.
This manual is according the latest technical knowing. Technical changings which are in the interest of progress
reserved.
We herewith confirm that the unit is calibrated by the factory according to the specifications as per the technical
specifications.
We recommend to calibrate the unit again, after 1 year.
®
© PeakTech 05/2005
< 25 ns at full amplitude (50 Ω) by 100 kHz (typical)
< 10 % of p-p at full amplitude (50 Ω)
< 1 % when f < 100kHz; < 30 dB when f > 100 kHz;
< 25 dB when f > 2 MHz
50 Ω ± 2 %
2 Hz to 12 MHz (PeakTech 1006);
2 Hz to 24 MHz (PeakTech 1013)
10 % to 90 %; up to 1 MHz
-10 V to +10 V into open circuit; -5 V to + 5 V into 50 Ω
Lin or Log up to 100:1
0.2 H - 100 Hz (5 sec. - 10 msec)
10 kΩ ± 5 %
0 to 10 V input causes 1:100 frequency change
Frequency: 5 Hz to 100 MHz
Period: 0.2 sec to 10 nsec
6 ½ digits
10 MHz ± 10 ppm (0° C to 50° C)
x 1, x20 nominal
50 mV sine wave to 50 MHz; 100 mV
rms
Supply voltage: < ± 0.5 ppm for ± 5 % variation; Aging Rate 1 ppm/yr.
Frequency: 10 MHz; Temp.: ± 1 ppm/°C, 0-40° C
3,5 kg
220 mm x 86 mm x 300 mm
0° to 40° C
-40° to 55° C
115/220 V AC; 50/60 Hz
sinewave to 100 MHz
rms
- 27 -