Ribimex Ribiland PRBAT20/CB Bedienungs- Und Wartungsanleitung Seite 26

3.4- Special warnings when using the product
1. Become familiar with the controls and the proper use of the tool.
Learn how to stop the tool quickly in an emergency.
2. The use of this product is forbidden to children. Individuals below the age of 16 and individuals
who are not perfectly familiar with the instructions, are not allowed to operate the machine
3. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of
the product by a person responsible for their safety.
4. Within the working area, the person using the machine is responsible for any damage or injury
sustained by third parties or their property which has been caused by the machine. Watch your
working area and do not allow third persons or animals to be around.
5. When operating the machine take great care and always hold it firmly with both hands.
Make sure you are in a stable and secure balanced position. The power tool is guided more securely
with both hands. Wait until the machine has come to a standstill before placing it down.
6. Make yourself familiar with your working area and be alert for possible hazards, which you might
not hear due to the motor noise.
7. Remain aware and remain cautious about foreign objects like wire fences, roots, debris... which
may damage the tube. Thoroughly inspect the working area where the machine is to be used and
remove all wires and any other foreign objects likely to pose a hazard.
Only work in daylight or in good artificial light.
8. Stay alert
Watch what you are doing. Use common sense. Do not operate tool when you are tired, under the
influence of alcohol, prescription medicines or drugs
9. Remarks
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
10. Important: Switch off the tool immediately upon occurrence of any of the following:
- Sparks on the brushes with smoke coming out of the motor housing.
- Deterioration of the switch.
- If smoke or if burnt smell appears.
- If tube gets blocked.
- The tool shall used as long as the cause of the malfunction has not been discovered and repaired by a
qualified technician.
Note: If you notice sparks when you release the switch, through the ventilation slots, that is part of the
normal operation of the tool and is not a default.
11. Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the tool's construction and design:
a. Damage to lungs if an effective dust mask is not worn.
Wear filtering mask protection while operating the power tool.
The use of this product may result in the creation of dust containing chemicals that may cause
respiratory or other diseases. These chemicals include compounds found in pesticides, insecticides,
fertilizers and herbicides. The risks associated with exposure to these products vary depending on
the frequency of this type of work. To reduce your exposure to these chemicals: work in a well-
ventilated area and with approved personnel protective equipment, such as dust masks specifically
designed to filter microscopic particles.
Page 26 / 89