Amewi BINARY V2 Bedienungsanleitung Seite 30

The binding process effectively ties the transmitter and receiver together. Under normal circumstanced, both items are supplied
like this from factory. If, however, you find that your transmitter and receiver are not bound (receiver's red LED will turn on), you
should do the following.
1. Set the sail control lever (left lever) to the lowest position, then switch on the remote control.
2. Switch on the receiver. Press and release the BIND button on the receiver. After flashing briefly, the green LED should light up
continuously.
Note: During the binding process, the transmitter and receiver should not be more than one metre apart. If the LED does not stop
flashing, repeat the procedure.
Before sailing your Binary for the first time, always switch on the transmitter before switch on the receiver and always switch off
the receive before switching off the transmitter.
1. For sail control stick, when stick is in position A, accordingly, the main boom and jib boom are in the position of A as shown.
When stick is in the position B, accordingly, the main boom and jib boom are in the position of B as shown.
2. You may adjust the sail servo neutral by pressing the sail neutral position trim button up or down.
3. For rudder control stick, rudder turn left when rudder control stick is pushed to the left. Rudder turn right when rudder control
stick is pushed to the right.
4. You may also adjust the rudder servo neutral by pressing the rudder neutral position trim button left or right.
5. Check to make sure the left and right rudder will move together in same direction when push rudder control stick on
transmitter.
Sail control stick
Sails neutral
position trim
TRANSMITTER & RECEIVER BINDING
PREPERATIONS FOR SAILING
BEDIENUNGSANLEITUNG/MANUAL BINARY V2
Rudder control stick
Rudder neutral
position trim
30