Elettro Synergic WF44 Anleitungshandbuch Seite 8

3.2 CONTROLS ON THE WIRE FEEDER REAR PANEL
(SEE PICT. 2)
S - Gas hose fitting for extension gas hoses.
T - 14-pin socket connector for 14-pin plug
connection.
U - Socket
Socket for the connection of the extension power supply
plug (+ pole).
V – Quick-fitting socket
This fitting must be connected to the red water hose
leaving the cooling unit.
Z – Quick-fitting socket
This fitting must be connected to the blue water hose
leaving the cooling unit.
4 START-UP
Assemble the welding torch on the central adapter G.
Make sure that the wire diameter corresponds to the one
indicated on the wire feed roller, and load the wire reel.
Make sure that the welding wire passes through the
groove in the roller.
Before connecting the generator power cable, make sure
that the supply voltage corresponds to that of the welding
machine, and that the earth socket functions properly.
Turn on the generator.
Remove the tapered gas nozzle.
Unscrew the contact tip.
Press the torch trigger and release it only when the
welding wire comes out.
Welding wire can cause puncture wounds.
Never aim the torch at parts of the body when loading
the welding wire.
Screw the contact tip back on, making sure that the hole
diameter corresponds to the wire used.
Slide the tapered gas welding nozzle back on.
8