Safety Note - BWT B100 Kurzanleitung

IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL THE INSTRUCTIONS
CAUTION: Do not plug power supply into outlet or turn power supply on if the robot is not
fully immersed in water. Operating the cleaner out of water will cause severe damage
immediately and will result in loss of warranty.
Allow the cleaner to remain in the pool for 15 to 20 minutes following the end of its
cleaning cycle. This will allow the motors to cool adequately. Do not leave the cleaner in
the pool all the time. Always remember to turn the power supply "OFF" and unplug it from
the power outlet before removing the cleaner from the pool.
WARNING: The cleaner must not be used when people are in the water. For use
with swimming pool only

Safety Note

- The unit must be supplied through a residual current device (RCD) having a
rated residual operating current not exceeding 30 mA
- The connection to the branch circuit should be consistent with the local and
national wiring rules (electrical code).
- Mishandling of the unit can result in leakage of lubricants.
- If the supply cord is damaged, it must be replaced by a special cord or assembly
available from the manufacturer or its' service agent.
This appliance can be used by children aged from 8 years and above with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
WARNING: A Ground Fault Current Interrupter (GFCI-USA) or a Residual Current
Device (RCD-EUROPE) must be installed to protect your electric outlet and prevent
any possible electric shock.
SAVE THESE INSTRUCTIONS
BWT B100 / B200 ROBOTIC POOL CLEANERS
5/12