Motorola PMLN7018 Bedienungsanleitung Seite 8

01_EN.fm Page 6 Monday, March 28, 2016 10:08 AM
M4x10mm
Screw (x4)
#8x.625" Self
Tapping Screw
(x4)
Hinge screw
Wipe clean flat surface
before using adhesive pad
Figure 2. When installing the cradle, use the following
procedure or modify to suit the particular vehicle
When installing the PMLN7018 Passive Vehicular Holder Kit,
follow the following procedure or modify to suit the particular
vehicle. See Figure 2:
1. Open the hinge screw and separate the two halves of the
mounting bracket.
2. Use the lower half of the bracket as a template. Position it
so that the pivot end of the bracket is toward the bottom
of the cradle.
3. Using an awl or similar device, make four holes in the
carpet at marked locations. This must be done prior to
drilling to avoid damaging the carpet.
4. Mark and drill holes. Securely mount the bracket half
using the four #8x.625" self tapping screws (supplied with
the mounting bracket).
5. Secure the cradle/holder to the other half of the bracket
using the four M4x10 mm screws, you may choose to
sandwich the RSM bracket in between or install it
separate as shown in Figure 2.
6. Connect the two parts of the mounting bracket and
secure the hinge screw.
7. Align the RSM bracket and the cradle to the mounting
bracket four holes. Secure with four M4x10mm screws.
RSM
Bracket
6