Setting The Dialling Mode - Clarity EXL30 Bedienungsanleitung

To reduce the risk of electrical shock, do not take this phone apart. Opening or removing covers
may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric
shock when the appliance is subsequently used.
Never install telephone wiring during a lightning storm.
Hereby, Plantronics BV declares that the Clarity™ EXL30 Amplified Telephone is in
compliance with the essential requirements and all other relevant provisions of
Directives 1999/5/EC and 93/42/EEC.
To view the Declaration of Conformity for this product please see
www.plantronics.com/documentation
Class I medical device
When the Amplified Indicator (14) is illuminated, the volume may be very loud and
in excess of 118dB.This mode is intended specifically for hearing impaired users.
GETTING STARTED
INSTALL BATTERIES
Please ensure this product is disconnected from the telephone line cable before
installing or replacing batteries.
To add extra brightness to the EXL30's Visual Ring Indicator (12), install one 9 Volt alkaline
battery (not included).
TO INSTALL THE BATTERY
Fig.A Use a pen to open the battery door (see instructions underneath the telephone unit)
Slide open the battery compartment cover on the bottom of the telephone, install the
battery, and replace the cover.

SETTING THE DIALLING MODE

Set the Dial Mode Switch (1) to T (tone) if you have touch tone DTMF service. Otherwise set
the switch to P (pulse).
CONNECTING FOR WALL MOUNT OR DESKTOP USE
WALL MOUNTING
Drill two holes in the wall 10.2cm (4") apart adjacent to the mounting holes on the telephone.
Use the correct screws to hang the telephone on the wall.
Fig. B Slide the handset hook out as shown in Fig. B and reverse its position so that the hook
points up and will hold the handset when you hang up.
Fig. C Insert the tabs of the phone base into the slots in the lower position of the base as
shown in Fig. C. Push the mounting bracket in and down firmly until it snaps into place.
Position on the wall close to your telephone wall socket.
Fig. D Connect the Telephone Line Cable and the Handset Cable to the telephone.
If required, use the supplied adapter.
Lift the handset and listen for a dial tone.
All manuals and user guides at all-guides.com
UK
8