Atag VA8018WTC Bedienungsanleitung Seite 50

Problem
The dishwasher's network symbol is not lit.
The dishwasher's network symbol is flashing.
Water remains in the dishwasher.
Bad odour in dishwasher.
The dishes are not dry enough.
22
Possible causes
The dishwasher has not been connected to the
local network.
The dishwasher has no connection to the local
network.
The dishwasher is connected to the local
network, but the router is not connected to the
cloud.
The filters are blocked.
The filters are not fitted correctly.
Debris in the drainage pump.
Drainage pump stop missing.
Kink in drainage hose.
Blocked drainage hose.
Dirt around the seals and in corners.
Low temperature programmes have been
selected for a prolonged period.
The dishwasher has not been used for a while.
Depending on the load, the programme's drying
cycle may be insufficient.
The dishwasher is not fully loaded.
Rinse aid needs topping up or dosage is set too
low.
The setting TAB is activated and all-in-one
detergent with insufficient drying effect is being
used.
Action
Connect the dishwasher to the local network.
See Network in the chapter Settings.
Check the connection to the router and that the
local network is in range of the dishwasher.
Make sure that other electrical devices will not
interfere with the dishwasher's connection to the
local network.
Check that the router is connected to the internet.
Reconnect the dishwasher to the local network.
See Network in the chapter Settings. If the
problem persists, call the service department.
Clean the coarse and fine filters.
Check that the filter handle is locked in the stop
position. The handle should point straight out
from the dishwasher.
Clean the drainage pump. See the chapter Care
and cleaning.
Check that the coloured stop on the right in the
bottom drain is in place. See the chapter Care
and cleaning.
Check that the hose is free from kinks and sharp
bends.
Disconnect the drainage hose where it connects
to the sink unit's water trap. Check that no debris
has fastened and that the connection has an
inner diameter of at least 14 mm.
Clean with washing-up brush and low foaming
cleaner.
Run a programme with a higher temperature
once or twice a month. Or run a self-cleaning
programme. See Self-cleaning in the chapter
Using the dishwasher.
Run a self-cleaning programme. See
Self-cleaning in the chapter Using the
dishwasher.
Activate the Extra Dry option.
Fully load the dishwasher.
Top up with rinse aid or increase the rinse aid
dosage level. See the chapter Settings.
Switch all-in-one detergents or deactivate the
setting TAB and top up with salt and separate
rinse aid. See Rinse aid in the chapter Settings.
Open the door a little once the programme has
finished.