Operation As Dmx Recorder; Step By Step Recordings; Rec Over Time Recordings - EuroLite EASY SHOW Bedienungsanleitung

Operation as DMX recorder

Easy Show can be used as a DMX recorder to record your own moods and chases from another DMX controller.
To do this, connect the controller to the DMX IN input. The DMX output is intended for your spotlights. There are
24 memory locations available via the four button groups 1-6 in the center. The recordings can be done step by
step or as time recording. Use the step by step storage mode if you need the fade function. The REC over time
storage mode, on the other hand, allows you to record complex sequences of a larger DMX console. The stored
programs can be called up and controlled as described in the chapter Operation.

Step by step recordings

1. Activate the recording function in the Enable Record menu item.
2. In the Memory Type menu item, select the step by step memory type for the desired memory location.
3. Exit the menu with BACK.
4. Briefly press the button of the memory location for recording.
5. Press the memory location button again for 3 seconds.
The display shows the memory location and steps:000.
CLCG01 steps:000
press 3s to save
6. Create the first mood on your DMX console and briefly press the memory location button to save the first step.
The display now shows steps:001.
7. Repeat step 6 to record further steps.
8. Finally, press the memory location button for 3 seconds to save the recording.
9. Recordings cannot be edited. Pressing a memory location button for a long time deletes the stored
programming.

REC over time recordings

1. Activate the recording function in the Enable Record menu item.
2. In the Memory Type menu item, select the REC over time memory type for the desired memory location.
3. Exit the menu with BACK.
4. Briefly press the button of the memory location for recording.
5. Press the memory location button again for 3 seconds.
The display shows the memory location and the duration of the recording.
CLCG03 00:00:00
press 3s to save
6. Briefly press the memory location button to start the recording. The display now shows ►.
7. Briefly press the memory location key to end the recording. The display now shows
8. Finally, press the memory location key for 3 seconds to save the recording.
9. Recordings cannot be edited. Pressing a memory location button for a long time deletes the stored
programming.
Note
Recordings are stored on the USB flash drive. You can easily duplicate the flash drive on a computer to
create backup copies. This allows you to continue working with the backup copy after a defect or
accidental deletion of programs. Rental companies can use this function to store special setups on
different flash drive for their customers.
29 • EN
.