Getting Started; Step 1: Connect The Usb Flash Drive; Step 2: Connect To Power Supply; Step 3: Connect Your Spotlights - EuroLite EASY SHOW Bedienungsanleitung

Power
adapter
DMX console

Step 1: Connect the USB flash drive

Easy Show is the easiest way imaginable to control your spotlights. In order for the device to work, first plug the
supplied USB flash drive into the UPLOAD/DATA USB port. All programs and settings are stored on the flash
drive.
Note
We strongly recommend that you make a backup copy of the flash drive. If the drive is lost or files are
accidentally deleted, you can continue working with the backup copy as usual.

Step 2: Connect to power supply

Connect the power adapter provided to the POWER INPUT jack and plug it into a power outlet. After use,
disconnect the power plug again to avoid unnecessary power consumption.

Step 3: Connect your spotlights

Connect the DMX OUT socket to the DMX input of the first fixture using a 3-pin DMX cable. Then connect the DMX
output of the first fixture in the chain to the DMX input of the next fixture. Always connect one output to the input of
the next fixture until all fixtures are connected. For the last fixture, it is often recommended that a terminator be
used. In most cases this is not necessary. Only if you notice a random flickering or twitching in your fixtures, this
can be a problem solver.

Step 4: Using a QuickDMX wireless receiver

Easy Show features a second USB port marked with QuickDMX. Here you can plug in an optional wireless
transmitter or receiver for the QuickDMX system from Eurolite. You can use this connector for wireless
transmission of DMX control signals to fixtures with a QuickDMX receiver. The receiver is already integrated in
some fixtures, for other fixtures it can be retrofitted. For information on how to set up the transmitters and
receivers, please refer to their instructions.

Step 5: DMX addressing

Finally, set the corresponding start address and, if necessary, the DMX mode for the spotlights. Which start
address and which mode are required, will be explained in the next chapter.

GETTING STARTED

Easy Show connection example
Program
Chase32 Step100
Flash drive QuickDMX receiver
21 • EN
DMX fixtures