Advanced Functions; System Settings - EuroLite EASY SHOW Bedienungsanleitung

In this chapter you will learn how to change important system settings and how to use the device as a DMX
recorder.

System settings

Press the MENU/BACK button to enter the system settings. Use the ▼/▲ buttons to navigate and set the options.
Press the ENTER button to jump forward one menu level. Press BACK to jump backwards and exit the system
settings.
Display
New Firmware
Sound Sens
DMX Merge
Channel Config
Memory Load
Memory Type
Enable Record
Factory Reset

ADVANCED FUNCTIONS

This function can be used to upload new firmware versions. The password is 1234.
Check the product page on www.eurolite.de for more information about this.
For setting the microphone sensitivity from 0 (low) to 100 (high).
The device can be used as a simple DMX merger. In this menu you define up to
which DMX address it generates the DMX signal itself and from which value it takes
over the signal of an external light controller.
Here you can set for each of the 512 DMX channels whether it is a dimmer channel
or a function channel. Dimmer channels are used for master dimming and fades,
function channels always remain at their stored value. First select the DMX channel
with ▼/▲, confirm with ENTER and then set the desired function with ▼/▲. Then
jump back to the channel selection with ENTER or to the main level with BACK.
Here you can assign other programs to the memory locations. The function is
included for future further developments and is currently not available.
DMX recordings can be made step by step or as time recording (REC over time).
Here you can define the desired storage type for each memory location. First select
the memory location with ▼/▲, confirm with ENTER and then set the desired
memory type with ▼/▲. Then jump back to the memory location selection with
ENTER or to the main level with BACK.
This function must be activated so that you can make DMX recordings. For this,
select the YES setting with ▼/▲ and jump back to the main level with BACK. After
recording programs, you should deactivate the function again so that unwanted
recordings do not occur.
This function is used to reset the device to the factory settings. The password for
this is 1234.
Function
28 • EN