Assembly - PELOTON BIKE Benutzerhandbuch

B I K E A S S E M B L Y
C O N T I N U E D
1 -3 4
5 6
7 8
24
A S S E M B LY
Fit the handlebar post onto the
1
handlebars. Make sure the letters on
the post will be upright when the
handlebar is right-side-up.
2 Add two flat washers and two M8×12
round head screws to the front of the
handlebar base. Screw them in with a
5mm Allen key.
3 Add two flat washers and two M8×10
round head screws to the sides of the
handlebar base. Screw them in with the
5mm Allen key.
4 Loosen the L-handle at the front of the
bike frame and slide the handlebar post
into the head tube.
5 Add an M5×15 Phillips head screw to
the hole at the end of the handlebar
post. Screw it in using a Phillips
head screwdriver.
6 Raise the handlebars to seat height and
tighten the L-handle.
7 Take four M5x12 round head screws
and add one flat washer and one spring
washer to each.
8 Secure each weight holder to the seat
slider using two screw-and-washer sets
and a 4mm Allen key.
9 1 0
1 1 1 2
1 3 1 5
A S S E M B LY
C O N T I N U E D
Rest the bike frame on the weight
9
holders and back foot.
10 Add the front stabiliser and four M8x20
socket cap screws. Screw them in with
a 6mm Allen key.
1 1 Rest the bike frame on the handlebars
and front stabiliser.
1 2 Add the rear stabiliser and four M8x20
socket cap screws. Screw them in with
the 6mm Allen key.
1 3 Remove the square panel from the back
of the touchscreen. Using a Phillips
head screwdriver and four M4x10
flange head screws, secure the
touchscreen to the monitor arm.
1 4 Return the back panel to
the touchscreen.
1 5 Push the monitor arm all the way into
the handlebars.
25