SBS Ekon Home Partner ECREMOTE8 Handbuch Seite 6

Use the direct code entry method in these cases.
2. Press and hold the SETUP button on the remote control until
the red LED turns on. Release the SETUP button. The red LED
will remain on.
3. Press and release the device button on the remote control
for the type of device you want to control (for example, TV,
decoder). The red LED will flash once and stay on.
4. With the remote control aimed at the device, press and release
the POWER button or the P + / P- button on the remote control
to start automatic code search. The red LED will flash once
and then stay on. The remote control has a delay of 6 seconds
before the start of the first scan.
5. The red LED will confirm each scan of a single code with a
single flash.
6. Press the OK button to save the code and exit the search. The
red LED will turn off.
Notes:
1. During code search, you can press the SETUP button to stop the
search and exit code search. The red LED will turn off and the
code will remain unchanged.
2. If all codes have been searched without success, the remote
control will exit automatic search and automatically return
to operational mode. The currently stored code will not be
changed.
PROGRAMMING THE "FAVOURITE" BUTTONS (if available)
This allows the user to programme up to 20 favourite channels
for quick access, five per button.
fav1 fav2
Up to five channels can be stored on each favourite button. Each
press of a button (fav1-4)
will scroll through the channels stored on it.
6
fav3 fav4 fav5