Lanaform IRT-100 Bedienungsanleitung Seite 4

Changing Temperature Scales
Ensure the thermometer is switched off.
1
Press the"SCAN"button for 8 seconds to
2
bring it into temperature mode. The current
temperature unit will be displayed.
Release and press the"SCAN"button again
3
to toggle and select between °C and °F .
The thermometer will switch off automatically
4
if it idles for more than 4 seconds.
DISPOSAL
Do not dispose of electrical appliances as unsorted municipal
waste, use separate collection facilities. Contact your local
government for information regarding the collection
systems available. If electrical appliances are disposed of
in landfills or dumps, hazardous substances
can leak into the groundwater and get into the food chain,
damaging your health and well-being.
EXPLANATION OF MARKS OR SYMBOLS
The following symbols may appear on the manual, Infrared
Thermometer and its accessories.
MUST OBSERVE
Means Obligatory with de-
tailed items expressed in
words or figures within or
beside the mark. Left one
means General Compulsory.
Follow instructions for use.
IMPLICATION OF SYMBOL
Type-BF applied part.
Caution: Consult accom-
panying documents.
Do not dispose this prod-
uct as unsorted munici-
pal waste. Collection of such
waste separately for spe-
cial treatment is necessary.
Transport package shall
be kept away from rain.
Transport package shall not
be exposed to sunlight.
Indicates correct up-
right position of the
transport package.
Contents of the trans-
port package are frag-
ile therefore it shall
be handled with care.
Indicates temperature lim-
its within which the trans-
port package shall be
stored and handled.
Non-ionizing electro-
magnetic radiation.
Do not roll.
Lot number .
Production date.
The device should not be
used after the end of
the shown or the day
Protected against solid for-
eign objects of 12.5mm di-
ameter and greater . Protect-
IP22
ed against vertically falling
water drops when the de-
vice is tilted up to 15° .
Manufacturer
CE Mark: conforms to es-
sential requirements of
the Medical Device Di-
rective 93/42/EEC.
Authorized Representative
in the European Community
Do not use the thermometer under tem-
perature extremes (below 16°C / 60.8°F
or over 35°C / 95°F) or humidity ex-
tremes (below 15%RH or over 80% RH).
* Failing to do so may cause inaccuracy.
Do not expose the thermometer to tem-
perature extremes (below -20°C / -4°F
or over 55°C / 131°F) or humidity ex-
tremes (below 15% RH or over 93% RH).
* Failing to do so may cause inaccuracy.
Temperature probe has been
shocked and lax.
* Contact your retailer immediately.
It is dangerous for patients to per-
form a self-evaluation and self-treat-
ment based on the measuring results. Be
sure to follow doctors' instruction.
* A self-evaluation may cause de-
terioration of diseases.
Don't touch or blow infrared sensor .
* A polluted or broken infrared sen-
sor may cause inaccuracy.
Clean a polluted infrared sensor with
a soft dry cloth in a gentle manner .
* Clean with toilet tissue or pa-
per towel may scratch the infra-
red sensor , causing inaccuracy.
Do not immerse the thermometer in liquids.
* This instrument is not waterproof.
Do not use a mobile phone near-
by when the thermometer is working.
* Portable and mobile RF communications
equipment can affect MEDICAL
ELECTICAL EQUIPMENT. Falling
to do so may cause inaccuracy.
Do not modify this equipment with-
out authorization of the manufacturer .
* Contact the retailer immediately.
The device is not repairable and con-
tains no user serviceable parts.
* If there is any problem, con-
tact the retailer immediately.
No modification of this equip-
ment is allowed.
* If there is any problem, con-
tact the retailer immediately.
If this equipment is modified, ap-
propriate inspection and test-
ing must be conducted to ensure con-
tinued safe use of the equipment.
* If there is any problem, con-
tact the retailer immediately.
WARNING