KIKKA BOO Vintage Bedienungsanleitung Seite 6

CHANGING THE SHOULDER STRAP LEVEL
1. Press the harness adjuster, pull the shoulder straps out to loosen completely ( g.1).
.
1
2. Remove the shoulder straps from the metal yoke, and undo the shoulder pads connector ( g.2/3).
3. Pull both the shoulder straps and pad straps out and re-thread them through the proper shoulder strap slot.
4. Reattach the shoulder straps to the metal yoke, then attach the shoulder pads to the shoulder pads connector. Make sure all straps are not twisted.
5. Pull the end of harness adjust strap towards you to tighten the should belt harness ( g.7).
6. Undo the head rest ties and reattach to slot above harness straps ( g.8).
7
INSTALLING REAR FACING (BIRTH TO 13KG)
11
1. Pull the red angle adjustment handle to adjust recline position Adjust the red arrow until it points to position 4 on the base. Hear a click to ensure it is locked into
position.
2. Place the car seat on the vehicle seat with 3-point vehicle safety belt ( g.13).
NOTE:
a. For Group 0+ the car seat must be rear facing, and must be in the position "4" on the base.
b. Only suitable on vehicle seat equipped with 3 point vehicle safety belts.
c. The vehicle seat belt must be pulled tightly and not twisted.
d. Never place a child rear-facing on a vehicle seat with airbag.
3. Pull the vehicle shoulder belt and route it through the shoulder belt guide on the backrest, and route vehicle's lap belt through the lap belt guides ( g.14).
14
2
Sceond
1 0
8
12
NOTE:
a. Make sure the vehicle seat belt has been pulled tightly and is not twisted.
b. Make sure the child car seat is placed rear-facing.
c. Make sure the child car seat is in position number "4".
3
Three
First
9
13