Balluff BAW M18MM-UAZ50B-BP00-507 Anleitung Seite 4

Inductive Distance Sensor
BAW M18MM-UAZ50B-BP00-507
Correct switching points in teach-in mode
1 Way a): Connect the sensor to the programmer.
Way b): Connect the Control input (C) through a
switch to + (Fig. 1).
2 Turn on programming mode: Hold the Prog button of
the programmer or the switch button down for at least
5 seconds. The first output is selected and cycles.
3 Select the switching point to be corrected: Press the
Prog button of the programmer or the switch button
for max. 2 seconds as often as required until the
desired switching output cycles.
4 Position the target object (machine member etc.) at
the desired teach point.
5 Save the switching point: Hold the Prog button of the
programmer or the switch button down for
2-4 seconds.
6 Return to operating mode: Press the Prog button of
the programmer or the switch button for
max. 2 seconds as often as required until no output
cycles any more.
After programming is complete, connect the sensor to
the user-side electronics. In operating mode a fixed
connection between the C input and ground is
recommended.
Dimensions
Fig. 3: Dimensions
Electromagnetic Compatibility
The product BAW M18MM-UAZ50B-BP00-507 is an
inductive proximity sensor with analog output and is
subject to EN 60947-5-7.
The additional binary outputs DA1, DA2, DA3 have
sensing and information processing functions. I. e. these
outputs are a representation of the analog output signal,
please refer to EN 60947-5-2 table 7 / line 3.
Balluff GmbH
Schurwaldstrasse 9
73765 Neuhausen a.d.F.
Germany
Phone +49 (0) 71 58/1 73-0
Fax +49 (0) 71 58/50 10
E-Mail: balluff@balluff.de
www.balluff.de
4
Technical Data
Effective operating voltage U
Supply voltage U
B
Ripple
Effective operating current I
Load capacitance DA1, DA2, DA3
Voltage drop U at I
d e
Linearity range s
l
Working range shift T at s
e
Load resistance R for analog output 2 kΩ
l
No-load supply current I at U
O
Differential travel H
Repeat accuracy
Non-linearity
Short/overload protected
Reverse polarity protected (+/–)
Ambient temperature T
a
Enclosure rating per IEC 529
Housing material
Active surface material
Connection type
24 V DC
e
21.6...26.4 V DC
< 10% of U
e
20 mA
e
< 100 nF
< 1.5 V
1...5 mm
±0.3 mm
< 20 mA
e
< 0.4 mm typ.
< 0.1 mm
±3 % of U max.
a
yes
yes
+10...+60° C
IP 67
Nickel plated brass
PBT
Cabel with connector
BKS-S 78M