DJI R Vertical Camera Mount Produktinformationen Seite 4

DJI OSMO accepts no liability for damage, injury or any
legal responsibility incurred directly or indirectly from
the use of this product. The user shall observe safe and
lawful practices including, but not limited to, those set
forth in this document.
Notwithstanding above, your statutory rights under
applicable national legislation are not affected by this
disclaimer.
RONIN is a trademark of SZ DJI OSMO TECHNOLOGY
CO., LTD. (abbreviated as "DJI OSMO") and its
affiliated companies. Names of products, brands, etc ,
appearing in this document are trademarks or
registered trademarks of their respective owner
companies.
Introduction
This DJI R Vertical Camera Mount enables the camera
to be installed vertically. Vertical Camera Mount can be
fixed on the axis arm of the pitching axis, which is
locked by the knob for quick disassembly and
assembly. The Vertical Camera Plate can slide up and
down to assist the camera to adjust the balance slightly.
The Built-in Quick Mounting Base is compatible with
two quick mounting boards. The side of Vertical
2