Diseqc Motor; Manual (Manual Channel Search); Pid(Pid Channel Search) - Digitallworld Sft-2000 Benutzerhandbuch

Setting up Your System

DiSEqC Motor

Select Satellite & Go to DiSEqC Motor menu by pressing OK button (Motor) in DiSEqC
Version menu.
1) Select the relevant value to search for the position.
2) Press OK button in "Drive" colume & start to run the motor pressing LEFT or RIGHT key.
The antenna is moving to the appropriate satellite position.
3) Press OK button to stop the motor & Save Position when the singal apprears in the menu
USALS
Please contact the installer of your satellite dish if you do not know the correct setting value
of each parameter listed in the above table.
Downloaded from www.Manualslib.com
• Note : USALS can be selected on Motor
Type.
- 16 -
Digital Satellite Receiver
manuals search engine
Setting up Your System
2. Press Red button (Auto) on the remote control in the Installation menu
to start the channel search.
• "Multi-Satellites search" is available after
setting each correct value.
3. Press the MENU or EXIT button to save the data & exit from the current menu.

Manual (Manual Channel Search)

Manual channel search is more convenient to
search a specific transponder using its
predefined information.
1) Press Green button(Manual) on the remote
control in Installation menu
2) Select each TP by pressing OK & Search
icon in the menu to start the search.
3) Press 'Add','Edit' & 'Delete' icon in the menu
as per your preference.

PID(PID Channel Search)

1) select the satellite in the installation menu
2) press Yellow button on the remote control
to begin the PID search on the selected
satellite.
You can find the channels by the specific
PID data
- 17 -
Digital Satellite Receiver