Setting Up Your System; Menu Tree; Main Menu; Installation(Satellite) - Digitallworld Sft-2000 Benutzerhandbuch

Setting up Your System

Menu Tree

Games
Preferences
Channel Editing

Main Menu

Main menu shows the following information.
Installation
System
Games
Preferences
Channel Editing
Downloaded from www.Manualslib.com
Search(Satellite)
Search(Terrestrial)
Status
Diagnostic
Factory Reset
Common Interface
Parental control
Language Setting
Time Setting
A/V Setting
UHF Tuning
Channel List
Favorite
1. Turn on TV and your STB, after you have
connected all peripheral devices to it.
2. Press the MENU button on the Remote
Control Unit. You will see the Main Menu on
the TV screen as follow:
3. You can move into the desired submenu using
UP/DOWN buttons.
4. Press the OK / button to confirm your
selection.
Main menu shows the following information
5. Press the MENU button to return to the
previous menu or press the EXIT button to quit
the Menu system completely.
Search Satellite, Search Terrestrial
Status, Diagnostic, Factory Reset, Common Interface
Parental control, Language Setting, Time Setting,A/V Setting
UHF Tuning
Channel List, Favorite
- 14 -
Digital Satellite Receiver
manuals search engine
Setting up Your System

Installation(Satellite)

This menu helps you to setup a variety of parameters necessary for receving signal and
managing the channel information. To avoid any loss of service, it is important to understand
the following before you make any changes.

Auto (Automatic Channel Search)

Automatic Channel Search helps you to automatically load the channel information of all
transponders contained in the selected satellite.
1. Select SATELLITE > DiSEqC switch or motor > LNB & the others in
order by pressing OK button.
Any unused port must be set " None"
• SATELLITE : You can select the satellite name.
• DiSEqC Version : You can use the DiSEqC 1.2 or USALS motorized system if it exists.
The Antenna automatically moves to the relevant Satellite Position when you select
channel from the channel list.
• DiSEqC Input : You can choose the DiSEqC Switch Number by pressing OK Button
• LNB Type/Frequency : You can select the predefined L.O Frequency by pressing OK and
LEFT/RIGHT buttons or manually enter a specific frequency in MHz unit by pressing
Numeric buttons.
• Search Type : Select the search mode of "All" or "FTA Only"
• Network Search : NIT channel search helps you to automatically load the channel
information of all transponders contained in a selected satellite.
• Provider Search : You can easily select & search the channel packages,which are pre-
defined as a default.
- 15 -
Digital Satellite Receiver