Power Saving Mode - Toshiba RAV-RM301MUT-E Bedienungsanleitung

7

Power Saving Mode

The power saving mode saves energy by limiting the maximum current which will effect heating or cooling capacity that the unit
can generate.
Push button during operation.
• The air conditioner enters power saving mode.
• appears on the display.
Power saving mode will stay in effect until it is cancelled.
To cancel the power saving mode, push
• disappears.
 To configure the power saving mode settings
5
1
Push button for at least four seconds when the air conditioner is not working.
• , symbol, and numbers flash.
2
Push (left side of the button) to select an indoor unit to be set.
• Each time the button is pushed, UNIT No. change as follows:
UNIT No.
1-1
The fan of the selected unit runs.
103-EN
button again.
1
3
2
4
UNIT No. UNIT No.
1-2 1-3
UNIT No.
1-4
3
Push TIME buttons, to adjust the power saving mode setting.
• Each push of the button changes the power level by 1 % within the range from 100 % to 50 %.
• The factory default is 75 %.
4
Push button.
5
Push button to complete the setting.
NOTE
• When other electric appliances are used at the same time, to avoid triggering the circuit breaker, power saving mode is
recommended. Of course power saving mode can be used to save energy as well.
• Power saving mode consumes less energy, but may not heat / cool the room as much as normal mode. (The maximum
current is limited to approximately 75 % (factory default) of the normal mode.)
• To adjust the power-save settings, see "To configure the power saving mode settings" in Power Saving Mode.
• Even when operation start / stop, operation mode change, or power reset is performed during the power saving mode, the
power saving mode is retained until the next operation.
– 52 –
Setting of power level in
power saving mode
104-EN