Safety Instructions; Electrical Connection - IKEA ISANDE AA-2242231-1 Bedienungsanleitung

ENGLISH
When the appliance is empty for long period, switch it off,
•
defrost, clean, dry and leave the door open to prevent
mould from developing within the appliance.
Do not store explosive substances such as aerosol cans with
•
a flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.

Safety instructions

Installation
Warning! Only a qualified person
must install this appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Do not use the appliance before installing
it in the built-in structure due to safety
manner.
• Follow the installation instructions
supplied with the appliance.
• Always take care when moving the
appliance as it is heavy. Always use safety
gloves and enclosed footwear.
• Make sure the air can circulate around
the appliance.
• At first installation or after reversing the
door wait at least 4 hours before
connecting the appliance to the power
supply. This is to allow the oil to flow back
in the compressor.
• Before carrying out any operations on the
appliance (e.g. reversing the door),
remove the plug from the power socket.
• Do not install the appliance close to
radiators or cookers, ovens or hobs.
• Do not expose the appliance to the rain.
• Do not install the appliance where there is
direct sunlight.
• Do not install this appliance in areas that
are too humid or too cold.
• When you move the appliance, lift it by
the front edge to avoid scratching the
floor.
• The appliance contains a bag of
desiccant. This is not a toy. This is not
food. Please dispose of it immediately.

Electrical connection

Warning! Risk of fire and electric
shock.
Warning! When positioning the
appliance, ensure the supply cord
is not trapped or damaged.
Warning! Do not use multi-plug
adapters and extension cables.
• The appliance must be earthed.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
• Always use a correctly installed
shockproof socket.
• Make sure not to cause damage to the
electrical components (e.g. mains plug,
mains cable, compressor). Contact the
Authorised Service Centre or an
electrician to change the electrical
components.
• The mains cable must stay below the level
of the mains plug.
6